Hoveround Powerchair Bracket | HVRND

Hoveround Powerchair Bracket

• The Hoveround Powerchair Bracket attaches to the underside of the armrest utilizing the existing screw located approximately 3 1/2" from the end of the armrest.  Remove the existing screw using an Allen wrench, insert the screw through the bracket on the counterbore side back into the armrest and retighten.
• Once installed snap the SnapIt! accessory into the bracket.
• Mounting arm attaches with screws to the underside of armrest chair. Bracket is specific to mobility device. Screw holes are pre-existing in armrest.
• Installation Instructions will be included with the bracket.
• Please note that the armrest in the instruction photos may be different in appearance than the armrest on your chair, however, the installation procedure is accurate.
• All holders come with a SnapIt! bracket. This item is a replacement or additional bracket for use on a second mobility device. Cup/phone holders can be snapped/attached to any bracket. 
  

Printable Installation Instructions